![Suburban/Yukon XL/Escalade EXT Tool Steel Standard and Oversized Bushings](http://endurapin.com/cdn/shop/products/Large_.02_{width}x.jpg?v=1649967498)
IN STOCK!
Tool Steel Oversized Bushings
Made from extremely abrasive resistant tool steel, hardened and hard chromed. These are built to last a lifetime of abuse.
Standard Size Bushings: These are recommended when there is no apparent wear to the bushing hole.
.02" Oversized Bushings: These are ideal for holes that are slightly worn where the standard size bushings would fit loosely into.
.06" Oversized Bushings: These are needed when the bushing hole has been severely worn. In cases where the hole is egg or oval-shaped, we recommend using JB Weld to fill the space around the bushing. This helps create a rigid bond to the bushing from the hinge plate.
See the diagram below for a better explanation of which bushings are referred to as small and large in the selection menu. These 4 different bushings are used across many GM vehicles so the bushing you need may be the same as the ones used on other vehicles.
These work with the corresponding EnduraPin models as well as stock pins.
Oversized Bushings Drill Bit Recommendations:
Small +.02": 1/2" Drill Bit
Small +.06": 17/32" Drill Bit
Large +.02": 17/32" Drill Bit
Large +.06": 9/16" Drill Bit
Note: You may still need to open these holes up slightly with a round file or die grinder. Remove a small amount of material and test fit the bushing constantly. You will want the bushing to fit in tightly.