GM Full Size Truck (C/K Series, Silverado, Sierra, K5 Blazer, Full Size Van) OBS Tool Steel Roller Pin
Couldn't load pickup availability
IN STOCK!
GM Full Size OBS Tool Steel Roller Pin. Gen 3.
These were designed to be the permanent replacement for your stock roller pin. Built extremely heavy-duty for a lifetime of service.
See the features on the diagram below.
Fits: 90s OBS GM Full-Size Vehicles FRONT DOORS (Silverado, Tahoe, Suburban, Full-size van)
Sold Individually, you will need to order two to replace both front doors.
Roller Pin Installation Guide:
Step 1: Remove the door detent spring.
Step 2: Grind or file away the factory staked roller pin head.
Step 3: Punch out the factory roller pin from the hinge plate.
Step 4: Clean the holes where the pin was.
Step 5: Insert your new EnduraPin Roller pin into the holes.
Step 6: Start threading the top tightening bolt into the body of the roller pin.
Step 7: You may need to gently tap the pin from the bottom with a hammer to get the knurled section into the hinge plate depending on how worn your hinge plate is.
Step 8: Tighten the top bolt into the roller pin using a 7/16" and an allen wrench.
Step 9: Re-install your detent spring.
